Page 74 - index

SECTION 3b
72
Skirmish 90 Rules
Diagram

1. Set-up
1.1 The track shall be straight and 90m long between the start and finish lines.
1.1.1 There should be barriers on both sides of the track for its full length.
1.1.2 Care should be taken the the barrier doesn't interfere with shooting the lower
targets (ie. T1 & T3)
1.1.3 There should be adequate run-in / run-out space at either end of the track, as per
General & Competition rules #8.5 .
1.2 The start and finish lines are clearly marked.
1.2.1 There is a strong preference for using electronic timing on this track* and the
timing gates will be located here.
1.3 The target faces shall be round and divided into 5 concentric circular zones,
1.3.1 For T1: the target face is 40cm diameter, with zones of 8cm, 16cm, 24cm, 32cm
and 40cm in diameter. A WA40 (FITA40) target may be used.
1.3.2 For T2, 3, 4 & 5: the target face is 80cm diameter, with zones of 16cm, 32cm,
48cm, 64cm and 80cm in diameter. A WA80 (FITA80) target may be used.
1.4 T1 is located at 0m (T1) along the track, ie. level with the start line.
1.4.1 T1 is set adjacent to the track facing parallel to the direction of travel on
horseback (ie. the target is not angled towards the track). The centre of the FITA40
AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA
AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA
AAAAAAAA